Fresh, Clean & Harmonized Air


The transformer used in this test was the memonizerCOMBI.


Many chemical pollutants that are now applied to furniture, along with sprays, cleaning agents and similar harmful substances are present in the air in our homes.  These are an unnecessary strain on our breathing and health in general.  The instances of allergies and breathing problems have greatly increased in the modern age.  Particularly since so much time in our lives are spent indoors.

A memon® device creates an abundance of natural negatively charged ions.  In effect this creates an environment whereby airborne particles and harmful agents are bound together and brought to the ground, where they cannot be breathed.  To give an example, healthy natural sea or mountain air typically contains around 3000 negative ions per cubic cm, whereas a typical flat would contain around 100.  Negative ions also have a great impact on body health and a positive attitude.










The two pictures above show the effects of greater numbers of positive (left) and negative ions (right) present in air.  Due to many factors, including electro smog, it appears that the normal balance of ions in the air are the positive ones.  This has the effect of allowing heavy particles, chemical pollutants and other airborne pathogenic information energies to linger in the air to be breathed.























0.3 micro meter sized particles.  Notice that over the two day period that without the transformer fitted (shown in silver colouring), particle numbers begin at ~ 730,000 and slowly drop to ~ 570,000.  With the transformer (shown in gold colouring) they have very quickly dropped and remain at a level with an average of 230,000.  This gives an overall improvement of 63% for this particle size.

















3 micro meter sized particles.  As expected, the particle numbers start high at the beginning of the test without the transformer (shown in silver).  They again slowly come down to the ground as the natural steeling down of airborne particles takes place.  With the transformer fitted (shown in gold)the particle content is again immediately and substantially reduced.  This time a little more pronounced than for the case of 0.3 micron particles (since these are slightly larger).   This gives an overall improvement of 81% for this particle size.
















10 micro meter sized particles. Again, without the transformer fitted (shown in silver) a natural high starting value and a steady decline is seen as before.  This time, an even greater immediate decrease in particle numbers for the case with the transformer fitted.  This then shows an overall improvement of 86%.

These tests show an average improvement (for particle ranges between 0.3 to 10 micro meters) of just over 76%.

Many who have experienced an environment that has the presence of a memon® transformer in this way comment on the sudden increase in dust on the floor over a short period after installation, accompanied by a noticeable difference in the quality of the air.  This dust presence is the result of the quick clearing of the air that had always contained such heavy particles.  People who have dogs for example, often note that the odours usually present are gone.

These tests were also carried out for memon® memonizerCOMBI’s fitted in many places including workshop areas. ALL of them showed comparable reductions in the presence of airborne pollutants.

The Institute for Bio-energy Product Testing (Institut fur Bioenergetische Product-und Warentestung) conducted tests on behalf of memon® to chart the presence of airborne pollutants.  The study was conducted in a building without and then with a memon® Four-System Combi Transformer fitted.  All doors and windows were kept closed and the test was ran over a two day period, with 8 sample measurements in each case.  Three sizes of airborne pollutants were measured which included 0.3 micro meter (one micro meter is one millionth of a meter), 3 micro meter and 10 micro meter particles, the results are displayed below.  In each case, the vertical measures are the particle numbers present and the horizontal ones correspond to one of the eight samples taken over the test period.  The green line indicates the average measurement across the eight samples for both cases (with and without a transformer):